![]() ![]() Install mounting bolt and torque bolt to 2.2 Nm (20 in lb). With 0-ring in place, install sensor and seat sensor by hand - to ensure proper gear engagement. NOTE: The speed sensor gear meshes with a gear on the output shaft. Ensure the 0-ring was removed with the sensor. These bolts can get very rusty and be tough to remove. If you dont have an air wrench, spray the drive shaft bolts with WD-40 or Liquid Wrench and let sit for a few minutes. Drive shafts are heavy components, so have a friend assist you if possible. Lift the sensor out of the transaxle extension housing. Dodge Neon 1998, CV Axle Shaft by SurTrack®. Step 2 Remove old drive shaft from the transmission. 24).ĭisconnect electrical connector from sensor. NOTE: The vehicle speed sensor is located in the transmission extension housing (Fig. Front Left CV Axle Shaft Built under strict quality control standards Tested for impact, wear and fatigue. This item: For Dodge Neon 1998 1999 Pair Front CV Axle Shaft - BuyAutoParts 90-903682D NEW 156.41 MOOG K90255 Ball Joint 26.53 MOOG ES80381 Tie Rod End 24. Parts fit for the following vehicle options. Shaft - Front Drive are shipped directly from authorized Mopar dealers and backed by the manufacturer's warranty. 1998 Dodge Neon Driveshaft & Axle Axle Assembly 1998 Dodge Neon Axle Assembly Change Vehicle. offers the wholesale prices for genuine 1998 Dodge Neon parts. Choose top quality brands A1 Cardone, Detroit Axle, DriveBolt, GSP, SurTrack. NOTE: When the sensor is removed for any reason, a NEW 0-ring must be installed on its outside diameter. Buy a 1998 Dodge Neon Axle Assembly at discount prices. The VSS pulse signal to the speedometer/odometer is monitored by the PCM speed control circuitry to determine vehicle speed and to maintain speed control set speed The sensor is driven through the adapter by a speedometer pinion gear. ![]() The Vehicle Speed Sensor (VSS) is a pulse generator mounted to an adapter near the transmission output shaft. I have provided info of where it is located. I don't have the test for this that I can find. ![]()
0 Comments
Leave a Reply. |